PJ-1614NXE PJ-2216NXE OPERATION MANUAL
4 Handling the printer
4.1 Introduction
This chapter explains how to handle the printer.
4.2 Drawing flow
The following flow chart illustrates the procedure for drawing with the printer.
Refer to each item as necessary.
1. Make the drawing data
Make the printing data using an application software.
2. Turn on the printer and load media into the printer.
3. Perform head cleaning before printing.
4. Make the preference setting for drawing with the printer.
5. Start drawing.
6. Perform after-printing operations.
CAUTION
During printing, do not touch the media guide. The media guide is hot, and may
cause burns if touched.
↓
3.6 Media handling
4.3 Using media
↓
3.7 Head cleaning before printing
↓
4.4 Menu setup on the operation panel
↓
4.5 Operating from the operation panel
↓
4.6 Operations after printing
4-1
4 Handling the printer