PJ-1614NXE PJ-2216NXE OPERATION MANUAL
3.3 Connecting the foot switch
The connection procedure for the foot switch is described below.
If the pressure roller needs to be raised or lowered, it is possible to control this motion from the foot
switch, instead doing so at the control panel.
CAUTION
• • • •
When handling the foot switch, be wary of the following:
• • • • Do not place anything heavy on the foot switch
• • • • Do not bend the cable of the foot switch with force, and do not pull.
• • • • Do not place the foot switch near thermal devices.
Install the foot switch according to the following procedure.
1.
Make sure that the power of the unit is OFF.
NOTE
•
The power is ON if the control panel displays the following conditions:
• The [POWER] key is in the pushed in condition
• The POWER lamp is lit (red).
Press the [POWER] key again to turn the power OFF.
2. Connect the foot switch cable connector to the foot switch connector on the rear face of the unit, and
fix into place with a screw.
No.
1
2
3. Place the foot switch on the floor under the stand.
Foot switch connector
Foot switch cable
Name
3-5
3 Basic Installation