6 Troubleshooting
6.4 When media jams occur
If the loaded media is jammed in the printer, follow the steps below to remove the jammed media.
6.4.1 How to remove the media (PJ-1614NXE)
CAUTION
Be sure not to pinch your fingers when you open or close the front cover.
1. Press [F2] key to raise the pressurizing roller.
• The MEDIA SET lamp goes off.
• The following message is displayed on the operation panel.
NOTE
•
When raising or lowering the pressurizing roller, you can use the foot switch instead of the control panel.
No
1
2. With holding the scroller, wind the roll media manually.
1
Foot switch
6-14
PJ-1614NXE PJ-2216NXE OPERATION MANUAL
Name