PJ-1614NXE PJ-2216NXE OPERATION MANUAL
3.7 Head cleaning before printing
Before printing, perform purge and head cleaning to clean the print head surface and the nozzle. Follow
the steps below for the head cleaning.
CAUTION
• • • •
When perform the head cleaning:
• • • • Put the gloves supplied with the printer on both hands.
• • • • Only use the print head wiper supplied with the printer. Otherwise the nozzle
may become clogged.
• • • •
The ink and jet wash liquid are poisonous. If skin contact occurs, wash with
soap water and rinse well.
1. Turn the unit power ON.
2. Verify that the unit is in a normal status.
3. Press the [F4] key of the control panel.
• Go on to the Purge menu.
4. Press the following keys on the control panel to change the settings.
• When changing the ink color: [F1] key
• When changing the purge mode: [F2] key
TIP
•
The factory default settings (initial values) are set as follows. Normally, there is no need to change the settings.
• Ink Color: All
• Purge mode: Normal
•
For details on the settings, refer to "4.5.4 Head cleaning".
5. Press the [ENTER] key of the control panel.
3-39
3 Basic Installation