Table of Contents
Advertisement
4 Handling the printer
NOTE
•
Use the recommended medias in an appropriate environment.
Following are the temperature and humidity ranges appropriate for printing.
• Temperature:18°C- 32°C
• Humidity:30%- 70% No condensation is allowed.
•
Do not use any of the following media.
• Media with crease, scar, tear, twist or media which tends to curl.
• Welded media
•
The size of the recommended medias can change at a fixed ratio according to the temperature changes of the
working environment. Before using the media, place the media in the working environment for at least 30
minutes, to have it match the temperature of the working area.
printing before media adjusts to the printing environment may cause media jams due to slippage or creases. This
also adversely effects the quality of printing.
•
Media has a printable side and a non-printable side. If you print on a not printable side, blurring or slight touching
may occur.
•
Do not touch the printable side of media. Moisture or oil from hands effects the printing quality.
•
Do not leave the printer for a long time with media loaded. The media may curl resulting in misalignment of
media, media jams, or decreased printing quality. In particular, avoid this in winter, dry seasons, or during final
printing.
•
Do not lose the box or rapping bag for storing media.
4.3.3 Precaution on storing media
When storing media, pay attention to the following.
NOTE
•
Store media away from high temperature, high humidity, or direct sunlight.
•
Unused roll media must be removed from the scroller, rewound tightly, and stored in the original wrapping bag
and the box.
•
Do not wet media.
4.3.4 The printing area
printing areas of each media with the printer are as shown below.
PJ-1614NXE PJ-2216NXE OPERATION MANUAL
4-4
Advertisement
Table of Contents
