5 Maintenance
5.5 Transfer and transportation
This section explains transferring and transporting the printer.
5.5.1 Transferring the printer
The following are instructions for transferring the printer.
CAUTION
• • • •
Keep the printer horizontal during transfer.
• • • •
Do not tilt the printer, stand it against a wall, or turn it upside down. Doing so
may cause ink to leak inside the printer. Also, movement after transport is not
covered by the warranty.
• • • •
Have two or more people transport the printer.
(1) Before the transfer
If you are using the stand, follow the steps below to transfer the printer.
1. Make sure that the printer is turned off.
2. Make sure that the head is in the right edge position (capping position).
3. Remove the scroller.
4. Disconnect the power cable and all other cables.
5. Release the locks on the casters.
6. The four adjusters are turned in the direction shown in the diagram.
7. Transfer the printer.
NOTE
•
The casters attached to the stand is designed for transferring the printer short distances on a surface in-house.
Rockhopper II - User's Guide
5-28