3.7 TRANSFER AND TRANSPORTATION
This section explains transferring and transporting the printer.
3.7.1 Transferring the printer
Following are instructions for transferring the printer.
(1) Before the transfer
If you are using the stand, follow the steps below to transfer the printer.
Make sure the printer is turned off.
Step 1 :
Make sure the head is in the right edge position (capping position).
Step 2 :
Disconnect the power cable and all other cables.
Step 3 :
The four adjusters are turned in the direction shown on the diagram.
Step 4 :
Transfer the printer.
Step 5 :
Notes
The caster attached to the stand has been designed for transferring the printer during short distances.
(2) After the transfer
Follow the steps below to prepare the printer to be used after the transfer.
Make sure that you place the printer on an adequate place.
Step 1 :
Connect the power cable and other cables.
Step 2 :
Perform a nozzle check to check if the printer head has clogged.
Step 3 :
Perform a fine adjustment of image quality.
Step 4 :
3.7.2 Transporting the printer
When you transport the printer, the printer should be repacked in the original box and packing materials, to
protect it from vibration or impact.
The printer should be in long store conditions.
Adjuster
1
Caster
2
Operation Instructions Spitfire 65/90 Extreme
35
CHAPTER 3 : BASICS
AP-77140 – Rev. 1.1 – 05/04/07