Transfer And Transportation; Transferring The Printer; Transporting The Printer - MUTOH Blizzard User Manual

3.7 TRANSFER AND TRANSPORTATION

3.7.1 Transferring the printer

Follow the instructions below when you want to move the printer to another location (on the same floor).
Caution
•
K
EEP THE PRINTER HORIZONTALLY DURING TRANSFER
•
D
O NOT TURN THE PRINTER UPSIDE DOWN
MOVEMENT AFTER TRANSPORT IS NOT COVERED BY THE WARRANTY
•
H
AVE TWO OR MORE PEOPLE TO TRANSPORT THE PRINTER
(1) Before the transfer
Step 1 : Make sure the printer is powered OFF.
Step 2 : Make sure the head is in the right edge position (capping position).
Step 3 : Disconnect the power cable of the printer, winding system and all other cables.
Step 4 : Turn in the four feet of the printer.
Step 5 : Turn in the six feet of the Unwinder/Winder 100.
Step 6 : Transfer the printer to its new location.
Notes
T
HE CASTERS ATTACHED TO THE STAND HAVE BEEN DESIGNED FOR TRANSFERRING THE PRINTER FOR SHORT
.
DISTANCES
(2) After the transfer
Follow the steps below to prepare the printer to be used after the transfer.
Step 1 : Make sure that you place the printer on an adequate place.
Step 2 : Connect the power cable and other cables.
Step 3 : Perform a nozzle check to check if the printer head has clogged.
Step 4 : Perform a fine adjustment of image quality.

3.7.2 Transporting the printer

When you transport the printer, the printer should be repacked in the original box if possible. Be sure to
install all buffers, such as head clamp, left maintenance cover, front cover...
The printer should be in long store conditions.
Notes
•
W
HEN YOU TRANSPORT THE PRINTER
•
T L S
O ONG TORE YOUR PRINTER
•
P
LEASE REFER TO THE INSTALLATION GUIDE FOR ALL DETAILS
.
. D
OING SO MAY CAUSE INK TO LEAK INSIDE THE PRINTER
,
CONTACT YOUR LOCAL
,
PLEASE REFER TO THE NEXT PAGE
42
.
.
MUTOH
DEALER FOR ASSISTANCE
.
.
User's Guide Blizzard
Chapter 3: Basics
. A
LSO
.
AP-75260 – Rev. 2.1 – 15/01/08
,