Grease The Turntable Rotation Bearing And Rotate Gear - Genie TMZ-34/19 Service Manual

June 2005
800-610-4101
ActionRental.com
REV C
A-11
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that
this procedure be performed every
100 hours of operation.
Regular application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an insufficiently greased bearing and gear
will result in component damage.
1 Locate the grease fitting on the inside of the
turntable rotation bearing.
The grease fitting is best located
through the bulkhead opening
behind the ground control box.
2 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of 4 to 5
inches / 10 to 13 cm at a time and repeat this
step until the entire bearing has been greased.
3 Apply grease to each tooth of the drive gear
located under the turntable.
Grease Specification
Chevron Ultra-duty grease, EP NLGI 2 (lithium based)
or equivalent
Part No. 52075
Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
TMZ-34/19 3 - 11