Perform Engine Maintenance (If Equipped); Grease The Turntable Rotation Bearing And Rotate Gear - Genie TZ-50 Servise Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-9
Perform Engine Maintenance
(if equipped)
Engine specifications require that
this procedure be performed every
50 hours or quarterly, whichever
comes first. Perform this
procedure more often if dusty
conditions exist.
Required maintenance procedures and additional
engine information is available in the Honda
GX160 Engine Owner Manual
(Honda part number 31ZH7630).
Honda GX160 Owner's Manual
Genie part number
3 - 10
A-10
Grease the Turntable Rotation
Bearing and Rotate Gear
Regular application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an insufficiently greased bearing and gear
will result in component damage.
1 Raise the boom enough to access the turntable
bearing.
2 Before serial number TZ5004-391: Locate the
grease fitting on the inside of the turntable
97228
rotation bearing.
After serial number TZ5004-390: Locate the
grease fitting below the ground control box.
3 Pump multipurpose grease into the turntable
rotation bearing. Rotate the turntable in
increments of 4 to 5 inches / 10 to 13 cm at a
time and repeat this step until the entire bearing
has been greased.
4 Apply grease to each tooth of the drive gear
located under the turntable.
Grease type
Genie TZ-50/30
November 2004
Genie specifications require that
this procedure be performed every
100 hours of operation.
Multipurpose grease
Part No. 84577
REV A