Table of Contents
Advertisement
When the protection circuit of the IR-320 operates (such as, in case of over-current or when
the temperature rises extraordinarily), turn off the side (main) power switch and leave it off
about 10 minutes after solving the problem; then turn on the side switch and the front power
switch in order again.
Note:
Be sure to use EPSON supplied or specified DIMMs, HDDs, and CPUs.
If you install a board in the PCI slot, use one that was confirmed by EPSON. Contact your
EPSON dealer for a list of approved devices. If you use any other device, please consider
that it is your responsibility to choose the correct device.
When installing an application, find out from the dealer where you bought it whether it is
appropriate.
About This Manual
Aim of the Manual
This manual was created to provide information on the IR-320 for anyone who is developing
applications.
Contents of the Manual
The table below is just a summary. A complete table of contents appears at the end of this
section. See it for detailed information and page numbers.
The configuration of the manual is as follows:
Chapter 1,"IR-320 System Overview"
Chapter 2,"Setup"
Chapter 3,"OS Information"
Chapter 4,"Utilities"
Chapter 5,"BIOS setup"
Chapter 6,"Device Diagnosis Utility"
Chapter 7,"Hardware Specifications"
Rev. C
IR-320 Technical Reference Manual
Describes the hardware configuration, the
software configuration, the jumper position,
and others
Describes how to set up the IR-320 and its
options
Describes the preinstalled OS (Windows 2000/
NT/98/95, MS-DOS) and the configurations
and setups of various drivers
Describes each utility and how to set them up
Describes the BIOS setup.
Describes the Device Diagnosis Utility
Describes items such as system, memory,
interruption, switch, and indicator
vii
Advertisement
Table of Contents
