28-Key Configuration Utility For Ms-Dos; Start - Epson IR-320 Technical Reference Manual

Error messages are shown below:
POS key error messages
Message
Firmware version is not correct
Invalid parameter
Communication error
Invalid pathname

28-Key Configuration Utility for MS-DOS

The 28-key configuration utility for MS-DOS can define the keys and Shift+keys on the 28-key
keyboard unit connected to the IR-320 in MS-DOS.
This program has been preinstalled in the following directory:
C:/Backup/Keycfg/DOS/
This program is stored on the floppy disk that comes with the 28-key keyboard unit and is
installed on the hard disk by executing the install program.
Key definitions
Number of definitions
Operation
Functions
See the table "Definable keys" on page 4-60 for the keys that can be defined.
Note:
Do not input from the keyboard while the defined keys are being written to the keyboard.

Start

During installation, the key definition utility for MS-DOS (POSKB28.EXE) is copied into the
specified directory. If no directory is specified, the utility is copied into the C:\POSKB directory.
Start this program as follows:
1. Exit Windows, and restart the system in DOS mode.
2. At the DOS prompt, type POSKB28, and press Enter.
4-58 Utilities
Description
Firmware version error, and others
Parameter error
Communication error
Pathname error
21 characters maximum per key
(Shift/Ctrl/Alt/Gray are each handled as one character)
Keyboard (mouse not available)
File 1. Designating a key-definition file
Load 2. Reading data from a key-definition file
Save 3. Writing data to a key-definition file
Edit 4. Editing a key-definition file
Download 5. Writing defined keys to the keyboard
Rev. C