Table of Contents
Advertisement
9. Press [Y] and [Enter]. The system will restart and after a short time, the License Agreement
will appear.
Strike a key when ready ... _
10. When you press any key, part of the License Agreement will appear. Repeat the same
procedure until you get to the end of the License Agreement. The following message will
appear.
Recovery Start from CD-ROM.
Please type
X: [enter]
start [enter]
A:\>_
11. Enter the following from the command prompt.
A:\> x: [Enter]
X:\> start [Enter]
12. The following message will appear. Select and enter the partition size of the HDD.
Please select the system partition size.
1: 10GB (Default size)
F: Full size of HD.
Please push a key of 1 or F._
13. Select the range to format as the system area on the hard disk. Press the "1" key to select
10GB or press the "F" key to select the full size. After that, the OS recovery starts.
14. The image data exchange dialog will appear. Insert the Windows 2000 CD-ROM 2 in the
CD-ROM drive; then press the OK button.
15. When the prompt below is displayed on the screen, OS recovery work is complete.
X:\RESTORE>_
16. Eject the "Windows 2000 CD-ROM" from the CD-ROM drive.
17. Reboot and start the BIOS setup utility.
18. Return the First Boot Device in the Advanced BIOS Features setup menu to the "Floppy."
19. On the main menu, select "Save & Exit Setup" and press Enter. The following dialog box
appears.
SAVE to CMOS and EXIT (Y/N)?
20. Press [Y] and [Enter]. The system will restart.
Limitation
Recovery cannot be performed starting from a hard disk. You must perform recovery from a
CD-ROM.
3-14 OS and Drivers
Rev. C
Advertisement
Table of Contents
