Table of Contents
Advertisement
1. The following dialog box is displayed if the check mark is removed from the Default item.
2. Each of the items below can be set if OK is clicked.
[Stabilization]
[Coordinates Data
Sampling Cycle]
[On]
[Frequency]
[Port]
[IRQ]
[I/O Address]
Rev. C
Set the jitter correction value within a range of 1 to 20.
The default setting is 1.
The jitter correction takes multiple samplings of the touch panel device's
coordinate data and calculates the average value to average and thus
stabilize the touch position. The Stabilization setting sets the number of times
coordinate data are sampled.
This sets the coordinate data sampling interval within a range of 10 to 155 ms.
The default setting is 10. The coordinate data sampling interval sets the time
coordinate data are sent to the system from the touch panel device.
This sets the tap sound On or Off. The tap sound is output if this item is
checked. The default setting is On.
This sets the tap sound frequency within a range of 37 to 16383 Hz. Dragging
the slider left or right changes the setting value. The default setting is 600 Hz.
This displays the port used. This item cannot be set here.
This displays the IRQ used. This item cannot be set here.
This displays the I/O address used. This item cannot be set here.
IR-320 Series Technical Reference Manual
OS and Drivers 3-61
Advertisement
Table of Contents
