Table of Contents
Advertisement
Confidential
Changing a Key Top
To change a key top on the keyboard unit, use the following procedure:
1. Insert the key top remover supplied with the keyboard unit into the key top that is to be
removed, as shown in the following figure:
2. When the key top remover is pulled up, the key top comes off.
3. To remove more than one key top, repeat steps 1 and 2.
4. Insert the new key top straight from the top.
Installing key top covers
Key top covers are supplied with the keyboard unit. The face of each key top is concave, and the
cover is installed on this key top. Install the key top cover using the following procedure:
Trim a piece of paper to the key size. Write down the key function on the paper, set it on the key
top, and install the key top cover on the key top. The key function can then be conveniently
identified at a glance.
1. Create a label for the key by trimming paper to the key size and writing the key function on
the label. Set the label on the key top.
Rev. C
IR-320 Technical Reference Manual
Setup 2-45
Advertisement
Table of Contents
