Table of Contents
Advertisement
Confidential
Receipt
Reduce35
6. After the installation of the APD is completed, the dialog to confirm the restart of the
computer is displayed. Click Yes.
7. Restart the system.
Setting a Printer driver and test printing
Set the printer driver and test print by following the steps below.
1. Start the system and choose Setting - Printer in the start menu.
2. The Printers dialog is displayed. Confirm that the icon of the installed printer driver is
displayed.
"Ex. for the TM-T88IIR"
EPSON TM-T88II(R)Receipt
EPSON TM-T88II(R)Reduce35 It prints as a reduction in the receipt paper size.
3. Click the icon of the printer driver for printing and right click and choose Properties from
the menu that is displayed.
4. Click the Ports tab and choose COM3 for "Print to the following port." Click Apply. More
than one printer driver can be set to the same port.
5. Click the General tab and click Print Test Page, and then the print of the test page starts.
Confirm that it is printed normally.
6. When the print of the test page is completed, the confirmation dialog is displayed. When it
is printed mormally, click OK and close the dialog.
Note:
When it is not printed normally, it is possibly caused by a mistake in the setup and the setting contents.
Refer to the procedure of "Installing a Dedicated Printer Unit" and "The Installation procedure of the
APD," and then reconfirm that it is set normally.
Rev. C
It is printed on the receipt paper without changing the character size.
It prints the print image of Windows in a reduced size: the receipt paper
size.
It prints at usual character size.
IR-320 Technical Reference Manual
Setup 2-73
Advertisement
Table of Contents
