Installing A Dimm (Memory) - Epson IR-320 Technical Reference Manual

Confidential

Installing a DIMM (Memory)

DIMMs (memory) are installed in the DIMM sockets on the main board.
One 128MB DIMM is standard on the IR-320. Two DIMM sockets (168-pin type), which can
increase the memory to 512MB, are available. Remove the DIMM originally installed, and install
the two DIMMs instead.
CAUTION:
Static electricity can damage the components of the IR-320. Before you touch any
components, touch a grounded metal surface to discharge the static electricity in
your body. It is also recommended that you wear a grounded wristband and work
on an antistatic surface.
Do not touch the DIMM connectors. Dirt may cause a malfunction.
If it is difficult to insert the DIMM, do not apply excessive force to the DIMM. If
excessive force is used, the connection parts may be damaged. Remove the DIMM,
check the connection part to confirm that no problem exists, and then insert it
again.
The DIMM is installed by using the following procedure:
1. Slide the right side cover down until it comes off.
2. Remove the two screws from the side panel, and remove the side panel by pulling it out
while lifting it.
Rev. C
IR-320 Technical Reference Manual
Setup 2-5