Table of Contents
Advertisement
Confidential
Depending on its type, the customer display may need the optional DM-D extension unit for the
IR series (DP-504) for connection to the IR-320. Check your customer display to determine
whether it needs the extension.
base
Operating progress
1. Set up the Customer display with the IR-320.
2. Turn on the power supply of the IR-320 and start up the Device Diagnostics Utility.
3. Confirm that the Customer display is connected correctly and displays correctly by using
the Device diagnostics Utility.
Setup procedure
Follow the procedure below to attach a Customer display.
1. Pass the cable for the DM-D500 through support A, and attach support A to the DM-D500.
When using support B for extension, insert the tab on support B into the hole on support A
until it clicks.
2. Attach the base to the attachment position on the IR-320.
Rev. C
fixing screws
IR-320 Technical Reference Manual
support A
support B
(for extension)
when using support B for
extension
Setup 2-63
Advertisement
Table of Contents
