Table of Contents
Advertisement
Confidential
The battery unit begins to be charged when the IR-320 main (side) power switch is turned on.
After installing a battery unit, set System Battery to Equipped using the Power
Management menu in the BIOS setup utility. (See Chapter 6.)
Note (for Users in the United States):
The battery unit (OI-R03) is powered by a nickel-cadmium battery, which is recyclable. At the end of its
useful life, it is illegal under various state and local laws to dispose of this battery into the municipal waste
stream. Call 1-600-8-BATTERY for information on how to recycle this battery.
Note:
The battery unit is not charged even if power is being supplied and the main power switch is on unless the
power is in full on mode.
The battery unit cannot be used for the IR-320 connected with the 3.5" HDD.
The battery unit has not yet been charged when it is purchased. Charge the battery unit before using it.
The nickel-cadmium battery must be recycled or disposed of properly.
The life of the battery unit is approximately 2 to 2.5 years. Replace the battery unit accordingly.
Install the battery unit following the steps below.
1. Remove the left side cover by sliding it downward.
2-40 Setup
Rev. C
Advertisement
Table of Contents
