Installing Service Pack 6A; Ultra Dma Setting For The Hdd - Epson IR-320 Technical Reference Manual

10. The [Intel(R) PRO/100 Family Adapter] is added to the network adapter. Click Next.
11. Select the network protocol. Set it to your system. Then click Next.
12. Select the network service. Set it to your system. Then click Next.
13. The confirm dialog box is displayed. When Next is clicked, installation starts.
14. The dialog box that specifies the directory of the copy origin is displayed. Insert the
CD-ROM of Windows NT in the CD-ROM drive and input D:\ (if the CD-ROM drive is the
D drive) and click OK.
15. In accordance with the environment used, continue the installation according to the
instructions on the screen.
16. When installing is completed, according to the instructions on the screen, reboot the system.
CAUTION:
If the network is installed after the setup, an error is caused in the logon procedure. After
installing the network driver, install Service Pack 6a.
Uninstalling the network driver
Uninstalling cannot be done.Uninstalling cannot be done.

Installing Service Pack 6a

This is installed by the exclusive installation program.
1. Insert the Service Pack 6a CD-ROM in the CD-ROM drive. Execute the
"Nt4sp6\Sp6i386.exe" on the Service Pack 6a CD-ROM.
2. The Setup Wizard starts, the License Agreement dialog box is displayed. Select [Accept the
license agreement] and click Install.
3. Installing is completed; then the dialog box is displayed. Click Restart.

Ultra DMA Setting for the HDD

You can set the HDD to the DMA mode by following the steps below.
1. Set the Service Pack 6a CD-ROM to the CD-ROM drive. Execute the
"Nt4sp6\Support\Utils\I386\Dmacheck.exe" in the Service Pack 6a CD-ROM.
3-42 OS and Drivers Rev. C