Setting File - Epson IR-320 Technical Reference Manual

Note:
This utility is available only with an English message.
This utility cannot be used while the key definition utility, such as 28KeyCfg, is in programming.
There is no keyboard or mouse response during reading or writing of settings.
Do not perform any operation that may cause interruption, such as tapping on the touch panel, during
reading or writing of settings.

Setting File

An example of the setting file for this utility is shown below.
[General]
IgnoreCommands=Off
SystemParam00=49,0
SystemParam01=&32,&f7
[MSR]
Beep=On
CodeType=US
ValidTracks=1,2,3,J
CodeDefinition00=48,10
CodeDefinition01=&31,11,Shift
CodeDefinition02=&32,&0A,Ctrl
CardStart=CS
CardEnd=CE
Track1Start=1S
Track1End=1E
Track2Start=2S
Track2End=2E
Track3Start=3S
Track3End=3E
JIS2Start=JS
JIS2End = JE
In the General section, an entry line that may affect the entirety is described, in principle.
IgnoreCommands may be specified to be On. When it is specified to be On, the setting of the
keyboard or MSR cannot be read or written.
SystemParamxx is described when the data is written in the system conversion area. The
offset and data of the variable are divided with [,] for specification. These two can be
specified by the byte width in the form of decimal or hexadecimal or character. For the
decimal specification, it is described as it is. For the hexadecimal specification, & should be
prefixed. For the character, $ should be prefixed. SystemParamxx may be described in more
than one file by describing decimal in xx from 00 in order up to 99.
Rev. C
IR-320 Technical Reference Manual
Utilities 4-49