Table of Contents
Advertisement
Key Definitions
Each key on the screen corresponds with each key position of the manager key. For defining
each key, use the following procedure:
1. Click the key you want to set to use this code, and it becomes selected. (Clicking it again
cancels the selection.)
2. Click Code, and open the KeyCode dialog box.
3. Input the code for the selected key from the keyboard. This code can be up to a maximum of
63 bytes.
4. If you click OK, the setting becomes valid, and the key dialog box is closed. If you click
Cancel, the setting is canceled. If you click Reset, the code is cleared.
Setting the Key Label
Use the following steps to set the key label displayed on the key position button.
1. Click the key you want to label, and it becomes selected.
2. If Label is clicked, the KeyLabel dialog box is opened.
3. Input any characters as the label.
4. If you click OK, the input characters are displayed on the button, and the KeyLabel dialog
box closes. If you click Cancel, the input characters are canceled. Up to 20 characters can be
input. "|" is regarded as a new line.
4-14 Utilities
Rev. C
Advertisement
Table of Contents
