Messages
The message portion of the screen displays the result of tests.
Table 6-6 Message area
Test category
TM printer
DM display
Drawer kick-out
Loop-back
LPT1 print
Use for the device diagnostic utility
Operating Procedure
When the device diagnostic utility starts, the following screen appears.
Rev. C
Message
Description
Disabled
This port is disabled.
Done
The TM printer test is completed. Check the printing motion and autocutter motion.
Disabled
This port is disabled.
Done
The DM display test is completed. Check display.
Disabled
This port is disabled.
Done
The drawer kick-out test is completed. Check the motion of cash drawer.
Error
The diagnostics test failed. This message also appears when a loop-back connector
is not connected or the wrong loop-back connector is connected.
Disabled
This port is disabled.
OK
The test completed successfully.
Time out
The printer connected to the LPT1 port did not enter a ready state after 2 sec.
Disabled
This port is disabled.
OK
The print data was sent successfully.
IR-320 Technical Reference Manual
Device Diagnostics Utility 6-7