Related Manuals for Epson IR-320
Summary of Contents for Epson IR-320
- Page 1 IR-320 User’s Manual / Bedienungsanleitung Gebruikershandleiding / Manuel d’utilisation Manual do utilizador / Manual del usuario Manuale dell’utente 404285000...
- Page 2 DM-LR104 series...
- Page 3 DM-LR121 series...
- Page 4 COM5 LAN LEDs COM6 COM2 COM1 Line-Out Line-In...
- Page 6 HDD LED power LED CD-ROM LED FDD LED power LED HDD LED LAN LED...
- Page 8 BaySwap viii...
- Page 9 DM-LR121 series DM-LR104 series...
- Page 11 733 MHz (FCPGA) Secondary cache 128 KB built-in Intel: Celeron 1.2 GHz (FCPGA2) Secondary cache 256 KB built-in Power management IR-320 BIOS supports Advanced Configuration and Power Interface (ACPI). ACPI controls power management function for the CPU, video, hard disk drive, and so on. DIMM sockets Two 168-pin DIMM sockets are provided on the main board.
- Page 12 Output voltage/frequency: Same as the AC input. Output ratings: The Output of the AC outlet is interlocking with the power on/off control in the IR-320. 252 × 457 × 261 mm {9.9 × 18.0 × 10.3"} Dimensions With rear cover: (W ×...
-
Page 13: Specifications
Seiko Epson Corporation’s operating and maintenance instructions. Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson Corporation. -
Page 14: Emc And Safety Standards Applied
NOTICE: The contents of this manual are subject to change without notice. Please contact us for the latest information. Copyright © 2003 by Seiko Epson Corporation, Nagano, Japan. EMC and Safety Standards Applied CE Marking... -
Page 15: For Canadian Users
Turn off the main power switch immediately and unplug the power cord if the IR-320 produces smoke, a strange odor, or unusual noise. Continued use may lead to fire or electric shock. Contact your dealer or an EPSON service center for advice. - Page 16 In particular, stay clear of devices that use large electric motors. Always connect the power cable to the IR-320 before plugging it into the wall outlet. Be sure to push the plug of the power cord all the way into the AC inlet of this product.
- Page 17 Be sure to use this product with all covers attached. Be careful not to cut your finger on any edge of the unit. Be sure to use EPSON supplied DIMMs, HDDs, CPUs, and KBs. To get the latest information about which CompactFlash Memory Card or Adapter or PCI board can be used with this product, contact your EPSON dealer.
-
Page 18: Charging The Battery
Before using the product, if the optional battery unit OI-R03 is installed, be sure to fully charge the battery unit.To fully charge the battery unit, leave the IR-320 with the power turned on for approximately 32 hours. Notes on Installing a Commercially Purchased... -
Page 19: Windows Xp
Press “No, I will restart my computer later.” and then press the Finish button. 13. Enter “Exit” at the command prompt to exit. 14. Remove the driver CD-ROM for the IR-320 and then insert the Windows XP CD-ROM. 15. Follow the onscreen instructions to enter the necessary information. -
Page 20: Re-Setting The Bios
Set the Date/Time. • Set the battery unit (OI-R03). 5. Load the setup default (already adjusted in advance so that the IR-320 can operate at its best). • Select “Load Optimized Defaults” with the cursor key; then press the Enter key.