Code Conversion Entry
CodeDefinitionNN = Character Code, Key Number, Shift Mode
CodeDefinitionNN : Specifies the character code to be defined. 'c' defines whether a character
Character Code
Key Number
Shift Mode
Shift
Control
Alt
List of key numbers (keys shaded in gray cannot be set)
Power Management Driver APM2.0
When this driver is installed, the following power management functions become available:
•
Turning off the power to the system after shutting down Windows NT
•
Notification that the front power switch was pressed
•
Notification that the AC power is abnormal
The Power Management Driver APM2.0 is attached to the battery unit (OI-R03-021).
Installation
When the driver has not yet been installed, install it by using the following procedure.
Note:
Install the driver after completion of all setting work for Windows NT, including the Service Pack.
Leave the installation work for the driver to a user qualified as an administrator.
1. Exit all applications under execution.
Rev. C
or numeral has been specified. Example: 'A' 0x41 65
: Sets values between 01h and 7Fh
: Specifies the key numbers shown in the table below
: Concurrent pressing key information
: Used for the scan codes with the Shift key
: Used for the scan codes with the Ctrl key
: Used for the scan codes with the Alt key
IR-320 Technical Reference Manual
Utilities 4-71