Setting The Dip Switches - Epson B113111 - DM D500 - Vacuum Fluorescent Display Character Installation Manual

Customer display

Hide thumbs

Table Of Contents

Table of Contents

DIP switch 2

DSW2

Function

No.

2-1

Y-connection (*1)

2-2

Self test selection (*2)

2-3

20 column and 2 line

mode selection (*3)

2-4

Device selection

default setting

2-5

Address 0

2-6

Address 1

2-7

Address 2

2-8

Reserved (*5)

(*1) The "Y-connection enable" is set when a TM printer with no modular jack for the DM-D is

connected with this product, using one COM port to connect both TM printer and DM

display. In this case, an optional DM-D stand (DP-501) and a connecting cable are required.

In cases other than above, choose "Y-connection disabled" (default setting).

(*2) This function can select whether or not you perform self test when turning on the power.

See "Self Test" for details.

(*3) When selecting "20 column and 2 line mode," this product can be used like the

DM-D105/106/205/206. In this case, the graphic display and the original functions for the

DM-D500 cannot be used; however, by selecting "256

(*4) When setting to "Printer is selected," data is sent to the TM printer, but is not displayed on

the display. When setting to "Display is selected," data is displayed on the display but is not

output from the TM printer. The selection can be changed using the <ESC=> command.

(*5) Stays at OFF setting.

Note:

The changes in DIP switch settings are effective when the power is

turned on again.

The data transmission setting, such as data length and transmission

speed, must be the same on both your computer and printer.