Center Staple Angle Adjustment - Konica Minolta bizhub C353P Service Manual

Field Service Ver. 1.0 Oct. 2007
8.2

Center Staple Angle Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When staple unit has been replaced.
• When a slant occurs in the position of the center staple.
A
Exit direction
[1]
6. Make another print and check the staple position.
1. Select the center staple mode and
make a print. (A3 Size)
2. Check the staple position for devia-
tion from the crease (Measure width
A).
Specification: 0 ± 1.5 mm
3. If the staple position is slanted as
shown on the left, make the following
adjustment.
4511F3C507DA
4. Release the lock release lever [1] of
the saddle unit.
5. Loosen the adjustment screw [2] and
[2]
move the lock lever to the left to
make the adjustment.
• If the staple position is slanted oppo-
site to the figure of step 2, move the
lock lever to the right to make the
adjustment.
4511F3C002DA
8. Mechanical adjustment
37