Finisher Adjustment; Center Staple Position Adjustment - Konica Minolta BIZHUB C203 User Manual

Utility mode
11.8

Finisher Adjustment

11.8.1

Center Staple Position Adjustment

The stapling position when printing with the "Center Staple & Fold" setting can be adjusted for each paper
size.
Note
[Center Staple Position Adjustment] appears if optional finisher FS-609 is installed or optional finisher
FS-519 is installed with the saddle stitcher attached.
If the angle of the staple must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to
Staple" and "Half-Fold" setting/"Center Staple & Fold" setting)" on page
For the procedure on adjusting the center folding position, refer to
page 11-50.
0 Adjust the center folding position before adjusting the center stapling position.
0 Before making any adjustments, use the "Center Staple & Fold" setting to print a single sample copy.
Perform the adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [1 Center Staple Position].
The Center Staple Position screen appears.
C353/C253/C203
11-34.
Finisher FS-519 + Saddle stitcher.
"Binding copies at the center ("Center
2-71.
"Half-Fold Position" on
"Displaying the Administrator
11
11-48