Punch Stop Position Adjustment (Pk-515) - Konica Minolta bizhub C353P Service Manual

7. Finisher operations
M. Accommodation Paddle
• Drive the storage paddle two turns
→ The operation is finished,
N. Output Paddle
• Drive the exit paddle one turn
→ The operation is finished,
7.3

Punch stop position adjustment (PK-515)

A. Control panel
<Inch area: 2 holes>
A
<Metric area: 4 holes> <Sweden: 4 holes>
A
4. Call the Service Mode to the screen.
5. Select [Finisher Adjust] → [CB-FN Adjust] → [PunchStopPosition].
6. Press the Menu/Select key.
7. Select the paper type and press the Menu/Select key.
8. Set the correction value using the
• To make width A wider, enter a positive value.
• To make width A narrower, enter a negative value.
• Adjustment range: +10 max. and -10 min. (1 increment: 0.5 mm)
9. Press the Menu/Select key.
10. Turn OFF the power switch, wait for 10 sec., then turn the switch ON.
11. Make a print and check the punch hole positions again.
66
<Inch area: 3 holes>
A
A
4512F3E502DA
or
Field Service Ver. 1.0 Oct. 2007
1. Set the printer into the hole punch
mode and make a 1-sided print.
2. Measure width A on the print and
check to see if the measured dimen-
sion falls within the specified range.
<Inch area: 2 holes, 3 holes>
Specifications: 9.5 ± 1.0 mm
<Metric area: 4 holes>
Specifications: 11 ± 1.0 mm
<Sweden: 4 holes>
Specifications: 11.5 ± 1.0 mm
3. If the measured width A outside the
specified range, perform the follow-
ing procedure to punch hole position
adjustment.
keys.