Replacing The Paper Feed Tray 2 Feed Roller/Paper Feed Tray 2 Pick-Up Roller - Konica Minolta bizhub C353P Service Manual

Field Service Ver. 1.0 Oct. 2007
6.5.7

Replacing the paper feed tray 2 feed roller/paper feed tray 2 pick-up roller

A. Periodically replacing parts/cycle
• Paper feed tray 2 feed roller: Every 300,000 prints
• Paper feed tray 2 pick-up roller: Every 300,000 prints
B. Procedure
1. Slide out the paper feed tray 2.
2. Remove the vertical transport door.
See P.101
3. Remove the rear right cover/2.
See P.99
[2]
[1]
[2] [3]
[1]
[1]
[2]
A02EF2C015DA
A02EF2C016DA
[2]
A02EF2C017DA
6. Periodical check
4. Remove the harness cover [1], and
disconnect the connector [2].
5. Remove four screws [1], and remove
the paper feed tray 2 paper feed
assy [2].
NOTE
• The paper feed tray 2 paper feed
assy is positioned by the shaft that
passes through the back frame of
the assy. When removing the paper
feed tray 2 paper feed assy, slide it
in the direction of the arrow.
6. Lower the jam clearing cover [1],
remove two screws [2], and remove
the paper feed tray 2 separation
roller assy [3].
25