Center Staple Position Adjustment - Konica Minolta BIZHUB 501 Copy Operations

Utility mode
12.6.2

Center Staple Position Adjustment

The stapling position when printing with the "Center Staple & Fold" setting can be adjusted for each paper
size.
Note
[Center Staple Position Adjustment] does not appear if optional finisher and Saddle stitcher are not
installed.
If the angle of the staple must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to "Binding copies at the center ("Center Staple
& Fold" setting)" on page 3-77.
For the procedure on adjusting the center folding position, refer to "Half-Fold Position" on page 12-45.
0 Adjust the center folding position before adjusting the center stapling position.
0 Before making any adjustments, use the "Center Staple & Fold" setting to print a single sample copy.
Perform the adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 12-42.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [1 Center Staple Position].
The Center Staple Position screen appears.
6
Touch the button for the paper size to be adjusted.
– If the paper size to be adjusted is not displayed, touch
displayed.
bizhub 501/421/361 (Version 2)
and until the desired paper size is
12
12-47