Konica Minolta bizhub C353P Service Manual page 107

Hide thumbs Also See for bizhub C353P:

Table of Contents

10. Firmware upgrade

6. Specify the drive of compact flash, which was recognized through the procedure 3, and

execute the "mkcf.bat." (Input the C: \bizhub\card_work>mkcf t1 f (drive number): in the

below figure, and push the "Enter".)

7. Once the "mkcf.bat" is executed, data writing into the compact flash is started.

8. Upon completion of writing, CHECKSUM is executed. If CHECKSUM value is precisely

matched, "VERIFY OK" appears.

9. Remove the compact flash from PC.

• When removing the compact flash, be sure to check if data is written as normal

and then remove it according to the precise removing method.

Field Service Ver. 1.0 Oct. 2007

A02EF2E282DA

4038F2E565DB

Chapters

Table of Contents