Konica Minolta bizhub C353P Service Manual page 411

16. Jig Software
C. JPEG check
• This function is available only when the optional scan accelerator kit (SA-501) is
mounted.
Functions
Use
• Not used.
Adjustment
Procedure
D. Memory Bus Check
Functions • To check to see if image data is correctly transferred from scanner to memory, and
from memory to printer.
Use • If the printed image is faulty.
Adjustment 1. Call the Service Mode to the screen.
2. Click these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [Mem-
Procedure
ory Bus Check].
3. Select either [Scanner → Memory], [Memory → PRT], or both.
4. Clicking the Start key will start the memory bus check and be terminated automati-
cally.
5. The check result will be displayed, [OK] or [NG].
E. Work Memory In/Out Check
Functions • To check to see if input and output of image data of work memory are correctly per-
formed.
Use • If the printed image is faulty.
Adjustment 1. Call the Service Mode to the screen.
2. Click these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [Work
Procedure
Memory In/Out Check].
3. Select either [Input Check], [Output Check], or both.
4. Clicking the Start key will start the work memory input/output operation check
sequence and be terminated automatically.
5. The check result will be displayed, [OK] or [NG].
F. HDD Version Up
Functions
• To upgrade administration data (Document management information, address infor-
mation, etc.) other than image data in HDD.
Use
Adjustment 1. Open the Service Mode.
Procedure 2. Set the following setting.
[State Confirmation] → [Memory/HDD Adj.] → [HDD Version Up]
3. Click the Start key to start upgrading the version.
4. When upgrading the version is complete, the outcome will be displayed on the
screen.
NOTE
• Make sure to turn power switch OFF when upgrading is complete, and wait for
ten seconds to turn back ON.
366
Field Service Ver. 1.0 Oct. 2007