Konica Minolta bizhub C353P Service Manual page 301

15. Service Mode
C. Leading (Duplex)
Functions • For individual types of paper, this function allows the adjustment of the image write
start position in the sub scan direction on the 2nd side of duplex printing.
Use • This adjustment is made when the image on the 2nd side of paper deviates from the
original position in the sub scan direction.
• This adjustment can be made independently for each of plain paper, thick 1, thick 2,
and thick 3.
Adjustment
Specification
Width A
Adjustment If width A is longer than the specifications, make the setting value smaller than the cur-
Instructions rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
Setting/ 1. Place A3 paper on the manual bypass tray.
2. Select [Service Mode] → [MachineAdjustment] → [Printer Area] → [Leading
Procedure
(Duplex)].
3. Select the [Plain Paper].
4. Select [Print] and press the Menu/Select key to let the machine produce a test pat-
tern.
5. Check the dimension of width A on the test pattern.
6. If width A falls outside the specified range, change the setting using the
keys.
7. Press the Menu/Select key to let the machine produce a test pattern.
8. Check the dimension of width A on the test pattern.
9. If width A is outside the specified range, change the setting again and make a check
again.
10.If width A falls within the specified range, press the Menu/Select key.
11.Following the same procedure, adjust for Thick paper.
256
Width A on the test pattern produced should
fall within the following range.
Specifications: 4.2 ± 0.5 mm
Backside
Setting range: -3.0 mm to +3.0 mm
A00JF3C504DA
Field Service Ver. 1.0 Oct. 2007
(in 0.2 mm increments)
and