Center Staple Angle Adjustment - Konica Minolta bizhub C250 Service Manual

8. Mechanical adjustment
8.2

Center Staple Angle Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When staple unit has been replaced.
• When a slant occurs in the position of the center staple.
A
Exit direction
[1]
36
1. Load a five-page A4 document in the
document feed tray.
2. Select the center staple mode and
make a copy. (A3 Size)
3. Check the staple position for devia-
tion from the crease (Measure width
A).
Specification: 0 ± 1.5 mm
4. If the staple position is slanted as
shown on the left, make the following
adjustment.
4511F3C507DA
5. Release the lock release lever [1] of
the saddle unit.
6. Loosen the adjustment screw [2] and
[2]
move the lock lever to the left to
make the adjustment.
• If the staple position is slanted oppo-
site to the figure of step 2, move the
lock lever to the right to make the
adjustment.
7. Make another copy and check the
staple position.
4511F3C508DA
Field Service Ver. 1.0 Aug. 2006