Forwarding Access Setting - Konica Minolta bizhub C353P Service Manual

16. Jig Software
C. Proxy Server
Functions • To set the address and the port No. of the proxy server.
Use • To use when accessing the server via proxy server.
Setting/ <Server Address>
Procedure • Enter an address using IPv4, IPv6, or FQDN format.
<Port Number>
• Enter the value between 1 and 65535 using the 10-key pad.
D. Connection Setting
Functions • To set the port No. and the time for timeout when accessing the FTP server, and also
to set whether or not to enable PASV mode.
Use • To use when accessing the FTP server.
• To use when connecting by the PASV (passive) mode (FTP server side will inform the
connection port before connecting).
Setting/ <Port Number>
Procedure • Enter the value between 1 and 65535 using the 10-key pad.
<Connection Time Out>
• Enter the value between 1 and 60 (min.) using the 10-key pad.
<PASV Mode>
• The default setting is OFF.
16.16.4

Forwarding Access Setting

A. User ID
Functions
• To register the user ID for accessing the program server where firmware is to be
stored.
Use
Setting/ 1. Select [User ID].
Procedure 2. Enter the user ID (up to 64 one-byte characters) on the on-screen keyboard.
B. Password
Functions
• To register the password for accessing the program server where firmware is to be
stored.
Use
Setting/ 1. Select [Password].
Procedure 2. Enter the password (up to 64 characters) on the on-screen keyboard.
376
ON
Field Service Ver. 1.0 Oct. 2007
"OFF"