Konica Minolta bizhub C353P Service Manual page 321

15. Service Mode
Step
Using the telephone line modem
Inputting the AT command for initializing the
modem
1. Select [Service Mode] → [CS Remote Care]
→ [Detail Settings].
2. Select [AT command].
3. Input AT command.
NOTE
• Change this command only when it is
necessary. (They do not need to be
changed in normal condition.)
• For details on AT command, see the man-
11
ual for the modem.
See P.286
Setting the DIPSW for CS Remote Care
NOTE
12
• This setting is not normally necessary.
Take this step only when necessary in a
specific connecting condition.
Executing the initial transmission
1. Select [Service Mode] → [CS Remote Care]
→ [Detail Settings].
2. Select [Basic Settings] → [Initial TX] →
[Start].
3. Press the Menu/Select key to start initial
transmission.
4. When the machine is properly connected
with the center, CS Remote Care setting
screen will be displayed.
NOTE
13 • The initial TX key at the right bottom of
the screen will be displayed only when
the center ID, the device ID, Telephone
number of the center and the device tele-
phone number have been input.
See P.284
276
Field Service Ver. 1.0 Oct. 2007
Procedure
Using E-mail
Setting the E-mail address
1. Select [Service Mode] → [CS Remote Care]
→ [Server Settings].
2. Select [RX Server], and set POP3 server
address, POP3 login name, POP3 password
and POP3 port number.
See P.286
3. Select [RX Settings], and set the E-Mail
address, AutoArrival Check, ConnectionTim-
eOut and APOP Auth.
See P.286
4. Select [TX Settings], and set the SMTP
server address, SMTP Port Number, Con-
nectionTimeOut, and Auth. Settings.
See P.286
5. Select [CommunicationTest], and press
Menu/Select key to carry out a transmission/
reception test. If it fails to exchange mes-
sages, see the error message to take neces-
sary measure, and try again.
See P.286
Proceed to step 13.
Receiving the initial connection E-mail mes-
sage
Sending the initial connection E-mail message
from the center to the address of the printer.
NOTE
• When receiving the initial connection E-
mail message from the center while CS
Remote Care-related screen is being dis-
played, the current setting information
will be deleted, and CS Remote Care set-
ting will be displayed.
• For sending the initial connection E-mail,
see the manual for CS Remote Care cen-
ter.
• Messages can be exchanged only
between the center with initial connection
and the printer.
• The initial connection from the center will
be carried out, and the E-mail address of
the center will be stored in the printer.
• When the initial registration is complete,
the E-mail address of the center will be
displayed by selecting [Service Mode] →
[CS Remote Care] → [Detail Settings],
[Basic Settings] → [E-mail].