10.5 Updating The Firmware With The Internet Isw; Outline; Service Environment; Preparations For Firmware Rewriting - Konica Minolta bizhub C353P Service Manual

Hide thumbs Also See for bizhub C353P:

Table of Contents

Field Service Ver. 1.0 Oct. 2007

10.5 Updating the firmware with the Internet ISW

• [Internet ISW] is the system where the firmware update instructions are sent to the main

body via either the control panel or the jig software so that the main body will automati-

cally receive the latest firmware data from the program server over a network. Using

Internet ISW allows updating the firmware while CE is visiting a customer site without

bringing the latest firmware data.

The following conditions are necessary for using the Internet ISW function.

• The main body is connected to such a network environment that the firmware can be

downloaded on the internet using the ftp or http protocol.

The "Internet ISW" will not operate under the following conditions.

• Power switch is set to OFF.

• When the following setting is set to "ON":

[Admin. Settings] → [Security Settings] → [EnhancedSecurity]

• The main body has the job currently performing.

• For using the Internet ISW, the network parameter, program server address as well as

firewall address need to be set to the main body.

• For details of each setting item, refer to Adjustment/Setting "Internet ISW".

A. Internet ISW Set

1. Start the jig software on the PC that has the software installed.

• Step 1 is necessary only for the setup from the jig software. Perform step 2 and

later regardless of whether the jig software or the control panel is used.

2. Call the Service Mode to the screen.

3. Select [Internet ISW Set] which is available from [Internet ISW].

10. Firmware upgrade

A00JF2E583DA

Table of Contents