Center Staple Angle Adjustment - Konica Minolta bizhub 362 Service Manual

Field Service Ver. 1.0 Dec. 2008
8.3

Center Staple Angle Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When Staple Unit 1 or 2 has been replaced.
• When a slant occurs in the position of the center staple.
A
Exit direction
[3]
[2]
[1]
5. Make another copy and check the staple position.
1. Set to Booklet + 2-point Staple and
2. If the staple position is slanted as
4511F3C507DA
3. Release the lock release lever [1] of
4. Loosen the adjustment screw [2] and
• If the staple position is skewed oppo-
site to the figure of step 2, move the
lock member to the right to make the
adjustment.
A0PGF2C534DA
8. Mechanical adjustment
Crease mode and make a copy.
Measure the width A of the paper.
Specification: 0 ± 1.5 mm
shown on the left, make the following
adjustment.
the Saddle Unit.
move the lock member [3] to the left
to make the adjustment.
35