Konica Minolta bizhub C353P Service Manual page 662

Field Service Ver. 1.0 Oct. 2007
11. Perform another test print and check the reference deviation.
12. Repeat the adjustment until the reference line falls within the specified range.
13. Tighten the adjustment screw.
14. Click [END].
15. Click [Exit] on the Service Mode screen.
16. Turn OFF the power switch, then wait for 10 sec. or more and turn ON the power
switch.
9. Open the right door.
10. Loosen the adjustment screw [1] and
[1]
[2] NOTE
• Do not damage the passage surface
A093F3C507DA
• If width A is greater than the specified
4348fs3512c0
• If width A is smaller than the specified
4348fs3513c0
7. Mechanical adjustment
turn screw D [2] to make the adjust-
ment.
of the right door.
value:
Turn screw D counterclockwise.
value:
Turn screw D clockwise.
27