Choosing To Waypoint - Furuno FCR-2107 Series Operator's Manual

11. Route Monitoring
Note: When you choose a route for monitoring, the message shown below may appear when the geometry of the
route makes it impossible to sail the ship. Choose the Plan Route dialog box and make necessary modifications.
11.2

Choosing TO Waypoint

When the connected Radar is
FURUNO or Radar which
communicates using IEC 61162-1
standard the monitor dialog box
looks like the figure at right. Note
that there is no control for visibility
of monitored route in this dialog
box.
To display this dialog box, choose
Route from the status bar, then click
the Monitor button.
When you have chosen a route to monitor, the system chooses a next waypoint automatically. Check that the To
waypoint is the desired one. The chart radar will automatically advance to a next waypoint when you pass the To
waypoint.
The chart radar automatically sets the last waypoint of your monitored route as the final waypoint.
To choose To waypoint, do the following:
1. Open the Monitor Route dialog box, choose Route from the status bar, then click the Monitor button.
2. Place the cursor in the To WPT box, then spin the scrollwheel to choose desired WPT.
3. Push the scrollwheel to confirm your selection.
11-2