Verifying Configuration Of Navigation Sensors - Furuno FCR-2107 Series Operator's Manual

6. ECDIS Overview
6.2.4

Verifying configuration of navigation sensors

The user can select navigation sensors for use in navigation and view their current values. There are "pages" for
speed and course and position. The figure below shows the SPD/CRS page.
Checkbox status shows whether the sensor is used for integrated navigation or not. If
there is no value shown for a sensor, it indicates that the sensor is not valid. Note that
the content of these pages depends on the sensors which are in use on the ship.
To display the SENSORS dialog box, place the cursor on the position indication in
the information area then push the right button.
Verifying SPEED settings (SPD/CRS page)
Select both Log and Dual log, if they are available, or select one of them, on the SPD/CRS page.
Note that manual speed should only be used in an emergency, when no other speed reference is available.
Remember that position sensors are also available as speed sources. If neither Log nor Dual log is available, you can
use a Ref tgt as the source for speed and course.
6-16