Sart (Search And Rescue Transponder); Sart Description - Furuno FCR-2107 Series Operator's Manual

3. Radar Observation
3.3

SART (Search and Rescue Transponder)

3.3.1

SART description

A Search and Rescue Transponder (SART) may be triggered by any X-Band (3 cm) radar within a range of
approximately 8 nm. Each radar pulse received causes it to transmit a response which is swept repetitively across the
complete radar frequency band. When interrogated, it first sweeps rapidly (0.4 µs) through the band before
beginning a relatively slow sweep (7.5 µs) through the band back to the starting frequency. This process is repeated
for a total of twelve complete cycles. At some point in each sweep, the SART frequency will match that of the
interrogating radar and be within the pass band of the radar receiver. If the SART is within range, the frequency
match during each of the 12 slow sweeps will produce a response on the radar display, thus a line of 12 dots equally
spaced by about 0.64 nautical miles will be shown.
When the radar to the SART is reduced to about 1 nm, the radar display my show also the 12 responses generated
during the fast sweeps. These additional dot responses, which also are equally spaced by 0.64 nautical miles, will be
interspersed with the original line of 12 dots. They will appear slightly weaker and smaller than the original dots.
Position of
SART
3-4
Screen A: When SART
is distant
Radar antenna
Echo from SART
beamwidth
24 NM
Own ship
position
SART mark
length
9500 MHz
9200 MHz
7.5 μs
Low speed sweep signal
Sweep start
High speed sweep signal
Screen B: When SART
is close
Lines of 12 dots
are displayed in
concentric arcs.
1.5 NM
Own ship
position
Radar receiver
bandwidth
Sweep time
95 μs
SART
Echo from
SART
Position of
SART