5.5.4
How to erase all waypoints
You can erase all waypoints from the menu. If there is an active route, this procedure
cannot be completed.
1. Open the menu.
2. Select [2 MARKS].
3. Select [8 DELETE DATA].
4. Select [3 ALL WAYPOINTS].
5. Select [YES] to erase all waypoints. Select [NO] to cancel the procedure.
Note: All routes are also deleted with this procedure.
6. Close the menu.
5.5.5
How to display the waypoint list
1. Open the menu.
2. Select [8 NAVLINE•WPT].
3. Select [7 WPT LIST]. The waypoint list appears.
4. Close the menu.
5.5.6
How to use the waypoint arrival area function
The waypoint arrival area lets you know when you are within a preset distance form
the next waypoint. When the waypoint arrival area is set, the next waypoint is shown
surrounded by an dashed orange-colored line.
For B-type radars only, you can also set a waypoint arrival alert.
Note: To use this alert, set [2 NAV LINE DATA SOURCE] in the [NAV LINE•WPT]
menu to [EXT DATA] or [INTERNAL DATA] before-hand. See section 5.5.1 for details.
Own ship
To set and use the waypoint arrival area function, fol-
low the procedure below.
1. Open the menu.
2. Select [8 NAVLINE•WPT].
3. Select [0 NEXT]. The second page of the
[NAVLINE•WPT] menu appears.
4. Select [2 WPT ARRIVAL DIST].
5. VIDEO PLOTTER OPERATION
Waypoint
arrival
distance
Waypoint
Alert area
WP1
35°10.178´N
135°45.123´E
WP2
35°28.036´N
135°57.293´E
5-15