Resetting Position Alignment - Furuno FCR-2107 Series Operator's Manual

15.6.3

Resetting position alignment

To reset position alignment, proceed as follows:
1. Open the Sensors dialog box then open the Position page.
2. Uncheck "Chart Align".
.
3. Check that the indication OFFSET is not shown in the upper part of the information area, to the right of the
position source indication.
HDG 071.0
SPD (WAT) 15.6 kn
SB (POSN) 0.0 kn
COG (POSN) 071.0
SOG (POSN) 15.6 kn
59°31.206'N
024°36.731'E
WGS 84
DGPS
°
°
15. Navigation Sensors
15-13