ARM ARM7TDMI Technical Reference Manual page 195

Symbol Parameter
T DOUT[31:0] hold time from MCLKf
dohu
T MCLKf to D[31:0] valid
dout
T MCLKf to DOUT[31:0] valid
doutu
T TCK to ECAPCLK changing
ecapd
T MCLKf to nEXEC and INSTRVALID valid
exd
T nEXEC and INSTRVALID hold time from MCLKf
exh
T EXTERN[1:0] hold time from MCLKf
exth
T EXTERN[1:0] set up time to MCLKf
exts
T Asynchronous interrupt guaranteed nonrecognition time, with
im
ISYNC=0
T Asynchronous interrupt set up time to MCLKf for guaranteed
is
recognition, with ISYNC=0
T MCLK HIGH time
mckh
T MCLK LOW time
mckl
T MCLKr to nTRANS, nM[4:0], and TBIT valid
mdd
T nTRANS and nM[4:0] hold time from MCLKr
mdh
T MCLKf to nMREQ and SEQ valid
msd
T nMREQ and SEQ hold time from MCLKf
msh
T MCLKf to nENOUT valid
nen
T nENOUT hold time from MCLKf
nenh
ARM DDI 0210C
Table 7-23 AC timing parameters used in this chapter (continued)
Copyright © 2001, 2004 ARM Limited. All rights reserved.
AC and DC Parameters
Parameter Figure cross
type reference
Minimum Figure 7-7 on page 7-8
Maximum Figure 7-3 on
page 7-5Figure 7-5 on
page 7-7
Maximum Figure 7-7 on page 7-8
Maximum -
Maximum Figure 7-1 on page 7-3
Minimum Figure 7-1 on page 7-3
Minimum Figure 7-13 on page 7-12
Minimum Figure 7-13 on page 7-12
Maximum Figure 7-11 on page 7-11
Minimum Figure 7-11 on page 7-11
Minimum Figure 7-17 on page 7-15
Minimum Figure 7-17 on page 7-15
Maximum Figure 7-1 on page 7-3
Minimum Figure 7-1 on page 7-3
Maximum Figure 7-1 on
page 7-3Figure 7-17 on
page 7-15
Minimum Figure 7-1 on page 7-3
Maximum Figure 7-3 on
page 7-5Figure 7-4 on
page 7-6Figure 7-7 on
page 7-8Figure 7-8 on
page 7-9
Minimum Figure 7-3 on page 7-5
7-23