ARM ARM7TDMI Technical Reference Manual page 193

Symbol Parameter
T Set up time of BREAKPT to MCLKr
brks
T TCK high period
bsch
T TCK low period
bscl
T TCK to data output valid
bsdd
T Data output hold time from TCK
bsdh
T Output enable time
bse
T TDI, TMS hold from TCKr
bsih
T TDI, TMS setup to TCKr
bsis
T TCKf to TDO valid
bsod
T TDO hold time from TCKf
bsoh
T nTRST reset period
bsr
T I/O signal setup from TCKr
bssh
T I/O signal setup to TCKr,
bsss
T Output disable time
bsz
T BL[3:0] hold time from MCLKf
bylh
T BL[3:0] set up to from MCLKr
byls
T MCLK to ECLK delay
cdel
T TCK to boundary scan clocks
clkbs
T MCLKr to COMMRX, COMMTX valid
commd
ARM DDI 0210C
Table 7-23 AC timing parameters used in this chapter (continued)
Copyright © 2001, 2004 ARM Limited. All rights reserved.
AC and DC Parameters
Parameter Figure cross
type reference
Minimum Figure 7-13 on page 7-12
Minimum Figure 7-18 on page 7-16
Minimum Figure 7-18 on page 7-16
Maximum Figure 7-18 on page 7-16
Minimum Figure 7-18 on page 7-16
Maximum Figure 7-20 on
page 7-17Figure 7-21 on
page 7-18
Minimum Figure 7-18 on page 7-16
Minimum Figure 7-18 on page 7-16
Maximum Figure 7-18 on page 7-16
Minimum Figure 7-18 on page 7-16
Minimum Figure 7-19 on page 7-17
Minimum Figure 7-18 on page 7-16
Minimum Figure 7-18 on page 7-16
Maximum Figure 7-20 on
page 7-17Figure 7-21 on
page 7-18
Minimum Figure 7-4 on
page 7-6Figure 7-8 on
page 7-9
Minimum Figure 7-4 on
page 7-6Figure 7-8 on
page 7-9
Maximum Figure 7-1 on page 7-3
Maximum -
Maximum Figure 7-14 on page 7-13
7-21