Connecting Hardwired Devices - GE 600-1064-95R b Installation Manual

Hide thumbs

Table of Contents

Mounting

Figure 1: XTi chassis and trim ring

To mount the panel on a wall:

Lay the panel flat on a table.

Remove trim ring (B in Figure 1 above) from panel by lifting at

notch (C in Figure 1 above).

Separate the panel chassis from the mounting plate by lifting

up on the tabs (A in Figure 1 above) and swinging the chassis

open.

Choose a panel location.

Run all necessary power, phone, siren, and hardwired contact

wires to the desired panel location.

When choosing the AC outlet location for the AC power

transformer, make sure the outlet is not controlled by a

switch or that it is not part of a ground fault circuit interrupt

(GFCI).

Hold the mounting plate against the wall and mark the

mounting hole locations (Figure 2 below) with a pencil.

Note: Mark both mounting holes in the middle of the

mounting slot. This will allow better adjustment of the panel

before securing it to the wall.

Figure 2: Mounting holes

Secure the mounting screws (provided) to the locations on the

wall marked in step 6. Do not tighten the screws. Leave

enough clearance to mount the mounting plate.

Note: Use wall anchors if no studs are present.

Mount the mounting plate to the wall. Insert the top mounting

hole first, then the bottom hole. Adjust the fit to make sure the

mounting plate is level. Hold the mounting plate in place and

tighten the screws.

Hang the panel chassis on the mounting plate at the plastic

hinges, swing the chassis up to the mounting plate and

engage at the tabs (A in Figure 1 above).

10. Reattach the trim ring.