Ix-8Ipnet / Ix-8Eipnet Ip Networking Card; Ix-Dti-T T1 Trunk Interface Card; Ix-T1Rcv T1 Dtmf Receiver Card - Iwatsu ENTERPROSE-CS Owner's Manual

Table of Contents

Advertisement

IX-8IPNET / IX-8EIPNET IP Networking Card

The IX-8IPNET/IX-8EIPNET IP Networking card provides 8 ports for IP
Networking use. The IX-8EIPNET is a daughterboard that can receive power
from either the IX-8IPNET (for a combined total of 16 IP Networking ports)
or the IX-8IPSUB (for a combined total of 8 IP Networking ports and 8 IP
station ports). The IX-8IPNET / IX-8EIPNET IP Networking card interfaces
with the Ethernet-based local area network (LAN) using one port on the LAN
switch (or router if no switch is used) before passing the voice traffic over a
fully managed network (such as a VPN).
The IX-8IPNET / IX-8EIPNET IP Networking cards use Session Initiated
Protocol (SIP) to establish a connection on an as-needed basis.
Ports: 8 ports/card
Additional Power: None
Voice Compression: G.711 or G.729

IX-DTI-T T1 Trunk Interface Card

The IX-DTI-T card interfaces the Iwatsu Enterprise-CS to one T1 span and has
the ability to support the following configurations: loop start trunk, ground
start trunk, E&M trunk, E&M tie, DID trunk, ANI trunk, DNIS trunk, single
line telephone, and off-premise telephone. In addition, the card may be
configured to provide the following clocking options: Master, Slave-Primary,
Slave-Backup or Slave-Private. The IX-DTI-T is not supported in the IX-
CME when the IX-T1RCV Receiver card is required.
Ports: 8, 16, 24 ports/card
Features: loop, ground, E&M trunk, E&M tie, DID, ANI, DNIS, OPX, SLT
Other Requirements: IX-PLLU, IX-T1RCV (optional), IX-8ERCV (optional)
Framing: SF or ESF with AMI or B8ZS

IX-T1RCV T1 DTMF Receiver Card

The IX-T1RCV is a receiver card that is only required if any of the T1
channels are receiving DTMF signals, i.e., DID, ANI, DNIS, E&M, TIE, or
OPX. This card provides eight receivers, dedicated to the first eight channels,
and allows the addition of two IX-8ERCV cards to provide a total of 24
receivers. Receiver circuits 9-24 are dedicated to channels 9-24 respectively.
Ports: None
Circuits: 8 DTMF Receivers
Location: Card slot to the right of the IX-DTI-T card
GENERAL DESCRIPTION - 43

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Iwatsu ENTERPROSE-CS

This manual is also suitable for:

Enterprise-cs

Table of Contents