Room Status - Iwatsu ENTERPROSE-CS Owner's Manual

Intercom Call Restriction
ECS may be programmed to restrict guest rooms from calling each other to
eliminate prank calls. Guests may still make intercom calls to the
Hotel/Motel's administrative extensions.
Message Waiting Control
Message Waiting Control allows you to inform a guest that there is a message
waiting for them by lighting the Message Waiting Lamp on the telephone in
their room. This operation allows you to send a message without having the
telephone ring.

Room Status

The keys on a Direct Station Selection Unit (DSS) may be programmed to
inform you of the status of your guest rooms. There are nine status
indications:
Room Status
Vacant-Ready
Vacant-To Be Cleaned
Vacant-Cleaned
Occupied (In Room)-Ready
Occupied (In Room)-To Be Cleaned
Occupied (In Room)-Cleaned
Occupied (Out of Room)-Ready
Occupied (Out of Room)-To Be
Cleaned
Occupied (Out of Room)-Cleaned
When the status of a guest room is changed from the OCCUPIED (IN
ROOM) status category to another category, the guest room telephone will be
restricted.
The maid may change the status of the guest room from TO BE CLEANED to
CLEANED by dialing a code from the guest room telephone. The supervisor,
after inspection of the cleaning, may change the status of the guest room from
CLEANED to READY (CLEANING CONFIRMED) by dialing a code from
the guest room telephone.
Wake-Up Call
Wake-Up Call allows you or a guest to enter a wake-up time. Guests are
notified by having their telephone ring five minutes prior to the time that was
set. If there is no answer to the first attempt, ECS will call the guest room at
IWATSU TELEPHONE USER GUIDE - 138
Key Lamp Outside Calls
off no
red-fast flash no
red-slow flash no
green yes
green & red-fast yes
flash
green & red-slow yes
flash
green-slow flash no
green-slow flash & no
red-fast flash
green-slow flash & no
red-slow flash